10-07-2017 09:49 AM
Hello - I am trying to set up a 4G router as a failover solution. Outbound traffic is working fine. If I query my external IP address with whatismyip, it reports an IP address that matches the WAN IP address issued by the network to the router. This suggests to me that no NAT translation is occurring. However the router never receives any inbound initiated traffic on any port that I have tried. I contacted EE technical support and they assured me that no inbound initiated traffic blocking happens on any port. A traceroute to the IP address of my router from a separate internet connection traces traffic into EE infrastructure but then times out. This also suggests to me that traffic is not NATted. I am using the everywhere APN.
Can anyone explain why I do not receive inbound initiated traffic?
10-07-2017 01:56 PM
To add - for diagnostic purposes I have connected the gateway directly to my laptop and monitored traffic between the two using Wireshark. The gateway is also set to respond to incoming pings over the air, but no responses are received.
10-07-2017 02:53 PM
What are the 1st 2 parts of your WAN IP addy?
EE mobile network uses Carrier Grade Nat (CGNAT), which means that you don't get your own IP address but share it with other users. So you can't be uniquely id'ed on the Net.
10-07-2017 03:09 PM
The first two parts are 178.110
I checked this and it is visible on the internet. I understood that you used CGNAT but don't understand my observations, which suggest a through route.
by Jneux 30-12-2017
by Gnomeface 23-12-2019