topic Connectivity hub won’t connect to main hub in Broadband & Landline

Connectivity hub won’t connect to main hub

Helen311 — Sat, 07 Mar 2026 18:55:11 GMT

My smart hybrid connect won’t pair with my main hub, they both turn aqua and the wifi works for two seconds then it starts flashing and turns off. What do I do ? Now it’s flashing green on the big one and red on the hybrid connect. Iv tried restarting it and it does the same thing several times.

Re: Connectivity hub won’t connect to main hub

JimM11 — Sat, 07 Mar 2026 19:46:32 GMT

@Helen311 Try the help options.

https://ee.co.uk/help/broadband/getting-started/hybrid-connect-set-up
https://ee.co.uk/help/broadband/fix-problem/fix-smart-hybrid-connect-broadband-problems

Re: Connectivity hub won’t connect to main hub

Helen311 — Mon, 09 Mar 2026 09:36:32 GMT

Hi ! Thank you for the link, I have done all of these methods suggested and still the wifi disconnects after a few minutes, it won’t pair and the smart hybrid is flashing red.

Re: Connectivity hub won’t connect to main hub

JimM11 — Mon, 09 Mar 2026 09:42:02 GMT

@Helen311 Which light is flashing red, the EE symbol or the 4G bars or both?

Connectivity Backup lights

flashing red - the device cannot connect to your hub. Try connecting the device and hub by ethernet cable or move the device closer to the hub

4G signal bars

flashing red - the device cannot connect to the mobile network. Connect the device and hub by ethernet cable or move the device closer to the hub

Re: Connectivity hub won’t connect to main hub

Helen311 — Mon, 09 Mar 2026 10:03:57 GMT

The ee symbol

Re: Connectivity hub won’t connect to main hub

JimM11 — Mon, 09 Mar 2026 10:11:30 GMT

@Helen311 Ok now the next, what EE hub are you using, see the link for those to look at. Pictures will say or you can look at the label on the actual hub or the box it came in.

https://ee.co.uk/help/broadband/getting-started/compare-our-range-of-broadband-hubs

Your 4G bars, they are all 3 lit up and steady operation 3 SOLID blue is the correct for a GOOD strong mobile 4G signal?

Re: Connectivity hub won’t connect to main hub

bobpullen — Tue, 10 Mar 2026 11:14:23 GMT

@Helen311 - to confirm, have you tried: -

Factory resetting both your hub and the Hybrid Connect unit by inserting something into the reset pinhole at the rear of the device for 30s or so and waiting a few minutes for it to reset/reboot.
Connect the two units using an Ethernet cable between LAN ports. Leave in this configuration for everything to hopefully settle/go steady aqua.
Remove the LAN cable and wait 5 mins or so for everything to hopefully settle again/go steady aqua.
Relocate the Hybrid unit where you want it, power it back up and wait another 5 mins or so for everything to hopefully settle again/go steady aqua.

In short: starting from a clean factory reset state and using wired, rather than wireless pairing, is your best bet of success.